Skip header
 

Top Page > Using the Fax Function > Sending a Fax > Specifying the Scan Settings > Specifying the scanning side according to the original (Type 2 model)

Specifying the scanning side according to the original (Type 2 model)

If you are using the Type 2 model, you can specify the machine to scan both sides of original automatically using the ARDF.

This section describes how to specify the scanning side according to the current original.

Important

  • If the machine is in Immediate Transmission mode, this function is not available.

1Press [Original].

2Press the [Up arrow key][Down arrow key] keys to select the desired scanning method, and then press the [OK] key.

Select the sides of the original (1 side or 2-sides) to scan. When scanning 2-sides, select the page and binding orientations according to the original.

Note

  • Press the [Escape] key to discard the current change and return to the initial screen.

  • If 2-sided scanning is specified, you must use the ARDF (scanning will not be possible with the exposure glass).

  • You can change the machine's default [Original] setting to always scan specific sides of originals.

  • Temporary job settings are cleared in the following cases:

    • When no input is received for the period of time specified in [System Auto Reset Timer] while the initial screen is displayed.

    • When the [Clear/Stop] key is pressed while the initial screen is displayed.

    • When the machine's mode is changed.

    • When the power is turned off.

    • When the machine's default for the same setting is changed.

Reference