Skip header
 

Specifying the scanning size according to the size of the original

This section describes how to specify the scanning size according to the size of the current original.

1Press the [Reduce/Enlarge] key or [Scn Size].

Reduce/Enlarge key illustration

2Press the [Up arrow key][Down arrow key] keys to select the size of the original, and then press the [OK] key.

If you selected anything other than [Custom Size], you do not need to perform the remaining steps of the procedure.

3Press the [Up arrow key][Down arrow key] keys to select [mm] or [inch], and then press the [OK] key.

4Enter the width using the number keys, and then press the [OK] key.

To enter a decimal point, press [Asterisk].

5Enter the length using the number keys, and then press the [OK] key.

To enter a decimal point, press [Asterisk].

Note

  • You can press the [Escape] key to exit to the previous level of the menu tree.

  • You can change the machine's default [Scan Size] setting to always scan originals with a specific scanning size.

  • Temporary job settings are cleared in the following cases:

    • When no input is received for the period of time specified in [System Auto Reset Timer] while the initial screen is displayed.

    • When the [Clear/Stop] key is pressed while the initial screen is displayed.

    • When the machine's mode is changed.

    • When the power is turned off.

    • When the machine's default for the same setting is changed.

Reference