Skip header
 

Top Page > Hardware Guide > Installing the Printer and Options > Installing Option > Attaching Paper Feed Unit

Attaching Paper Feed Unit

WARNING

  • Touching the prongs of the power cable's plug with anything metallic constitutes a fire and electric shock hazard.

WARNING

  • It is dangerous to handle the power cord plug with wet hands. Doing so could result in electric shock.

CAUTION

  • Before installing or removing options, always disconnect the power cord plugs from the wall outlet and allow time for the main unit to fully cool. Failing to take these precautions could result in burns.

CAUTION

  • The machine weighs approximately 12.4 kg (27.4 lb.). When moving the machine, use the inset grips on both sides, and lift slowly. The machine will break or cause injury if dropped.

CAUTION

  • Lifting the paper feed unit carelessly or dropping may cause injury.

CAUTION

  • Unplug the power cord from the wall outlet before you move the machine. While moving the machine, take care that the power cord is not damaged under the machine. Failing to take these precautions could result in fire or electric shock.

Important

  • Tray 1 is required to print using the optional paper feed unit. Without Tray 1, paper jams will occur.

  • Do not grip on the tray area when lifting the printer.

1Check the package contains Paper Feed Unit.

Paper feed unit illustration

2Turn off the printer's power switch, and then unplug the printer's power cord from the wall outlet.

3Remove the adhesive tape from the optional paper feed unit.

Paper feed unit illustration

4Lift the printer using the inset grips on both sides of the printer.

Printer illustration

5There are three upright pins on the optional paper feed unit. Align them with the holes on the underside of the printer, and then carefully lower the printer.

Printer illustration

6After installing the option, print the configuration page to confirm the installation.

Note

  • When moving the printer, remove the optional paper feed unit.

  • Before using the optional paper feed unit, you can make settings in the printer driver.

  • If the new device is listed in the column of configuration options, then it has been properly installed.

  • If the optional paper feed unit is not installed properly, reinstall it following this procedure. If you cannot install it properly even after attempting reinstallation, contact your sales or service representative.

Reference

  • For printing the configuration page, see Software Guide.

  • For loading paper into the paper tray, see Loading Paper.

  • When adjusting the printing position, see Software Guide.