Skip header
 

Box Settings

This section describes Box Settings.

The following functions are for delivery and transfer of documents:

SUB Code and SEP Code

SUB Code and SEP Code are IDs consisting of up to 20 digits, and can include numbers, [Sharp], [Asterisk], and spaces.

To use this function, you must program a box and SUB/SEP Code beforehand. The other party can send documents to, and retrieve stored documents from, this box using the code.

Note

  • For the maximum total number of Personal Boxes, Information Boxes, and Transfer Boxes that can be registered, see Maximum Values.

  • You cannot set the same box code on two different boxes.

  • Transmission or programming may not be allowed if there is not enough free memory left. The amount of free memory left differs depending on the optional equipment installed.

  • If a parameter other than [Print] is set to [Output Mode] in [General Setting] under [Output Mode Switch Timer] in [Reception File Settings], Personal Boxes, Information Boxes, or Transfer Boxes may not be modified or deleted. If this is the case, check the [Output Mode Switch Timer] setting.