Skip header
 

Scanning Two-Sided Originals

Use this function to scan the front and back side of two-sided originals page by page.

You must place originals into the ADF and use Memory Transmission when using this function. The exposure glass and Immediate Transmission cannot be used with this function.

How to specify the orientation and page opening orientation settings

To transmit the original so that its front and back sides can be printed in the same orientation, configure the "Original Orientation" and "Page Opening Orientation" settings according to the orientation of the original to be placed.

Unless the "Original Orientation" and "Page Opening Orientation" settings are configured properly, the orientation of the front and back sides of the original may be in reverse when printed at the destination.

Original

Original position

Original Orientation

Page Opening Orientation

Illustration of two-sided originals

Illustration of two-sided originals

Operation panel screen illustration

Top to Top

Illustration of two-sided originals

Illustration of two-sided originals

Operation panel screen illustration

Top to Bottom

Illustration of two-sided originals

Illustration of two-sided originals

Operation panel screen illustration

Top to Top

Illustration of two-sided originals

Illustration of two-sided originals

Operation panel screen illustration

Top to Bottom

1Press [Original Feed Type].

Operation panel screen illustration

2Specify the original orientation.

Select the readable orientation Operation panel screen illustration or unreadable orientation Operation panel screen illustration according to the orientation in which you place the original.

Operation panel screen illustration

3Press [2 Sided Original].

4Select [Top to Top] or [Top to Bottom].

5Select [1st Sheet] or [2nd Sheet].

Select [2nd Sheet] if you want to send a cover sheet as the first page.

6Press [OK].

Note

  • You can confirm whether both sides were properly scanned using the Stamp function. For details about Stamp, see Stamp.

  • For details about acceptable original size and paper thickness for two-sided scanning with the ADF, see "Recommended Original Sizes and Weights", Paper Specifications and Adding Paper.