Skip header
 

Interrupt Copy

Use this function if you want to interrupt a long copy job to make urgently needed copies.

Important

  • You cannot use the Interrupt Copy function when fax originals are being scanned or the scanner function is being used.

  • You cannot use the Staple function with this function if another copy job is already using the Staple function.

1Press the [Interrupt] key.

Interrupt key illustration

The machine stops scanning.

2Remove the originals that were being copied.

3Place the originals you want to copy.

4Press the [Start] key.

The machine starts making copies.

5When copying is complete, remove the originals and copies.

6Press the [Interrupt] key again.

7Replace the originals that you were copying, and then press the [Start] key.

Following the instructions on the screen.

Note

  • The previous copy job settings are restored. Simply press the [Start] key to continue copying from where it left off.