Skip header
 

Erase Centre/ Border

Erases both the center and edge margins of the original image.

There are two types in the Erase Centre/ Border mode.

Same Width

Erase the same width of edge margins of the original image. However, only the center part of originals can be erased at a different width from the edge.

Different Width

Erase the edge margins and center part of the original image at different widths.

1Press [Edit / Stamp].

Operation panel screen illustration

2Press [Erase].

3Press [Erase Centre / Border].

4Press [Erase Centre/ Border].

5Select [Same Width] or [Different Width].

6Press the key you want to change, and then specify an erase width with [Plus] and [Minus].

If [Same Width] is selected in step 5:

Operation panel screen illustration

If [Different Width] is selected in step 5:

Operation panel screen illustration

7Press [OK] twice.

Note

  • Pressing [Plus] or [Minus] changes the width in increments of 1 mm (0.1 inches). Pressing and holding down the relevant key changes the width in increments of 10 mm (1 inch).