Skip header
 

Margin Adjustment

Copies originals leaving a binding margin.

Illustration of Margin Adjustment

1Press [Edit / Stamp].

Operation panel screen illustration

2Make sure that [Margin Adj.] is selected. If [Margin Adj.] is not selected, press [Margin Adj.].

3Specify a binding margin for the front side pages.

Operation panel screen illustration

4Specify a binding margin for the back side pages.

Margin on the back side of the page is valid when [1 Sided 2 Sided] or [Combine 2 Sides] is selected.

If you do not need to specify the margins for the back side pages, proceed to step 5.

5Press [OK].

Note

  • You can specify the binding margin up to 30 mm (1.2 inches) in 1 mm (0.1 inches) increments.

  • Press [] and [] to specify the top or bottom position. Press [] and [] to specify the left or right position.

  • If you specify a binding margin that is too wide, part of the image may not be copied.

  • When making copies in Combine mode, the binding margin is added to the copies after the combination is finished.

  • You can change the settings for Margin Adjustment under [Edit] in User Tools. For details, see Edit.

PreviousNext