Skip header
Help
 

Top Page > Hardware Guide > Maintaining the Printer > Cleaning the Registration Roller

Cleaning the Registration Roller

If the registration roller is dirty, a misfeed might occur. In this case, clean the roller as follows:

WARNING

  • Be sure to turn off the power switch and wait for about 15 minutes before cleaning the Registration roller. Not waiting for the printer to cool down can result in a burn.

CAUTION

  • The inside of the machine could be very hot. Do not touch the parts with a label indicating the "hot surface". Otherwise, an injury might occur.

Clean the registration roller if dots (caused by specks of paper stuck to the roller) appear on printed OHP transparencies.

Important

  • Do not hold the print cartridge upside down or stand it vertically.

  • Do not put the print cartridge on an unstable or tilted surface.

  • Do not use chemical cleaners or organic solvents such as thinners or benzine.

1Turn off the power, and then unplug the power cable.

2Open the front cover by pushing the front cover release button.

Printer illustration

3Pull the print cartridge out of the printer by holding the grips of the cartridge.

Printer illustration

4Wipe around the metallic registration roller by turning with a soft damp cloth.

Inside of the printer illustration

5Holding the grips of the print cartridge, push it into the printer until it stops.

Printer illustration

6Close the front cover.

Printer illustration

Note

  • Carefully close the front cover. If you cannot close the cover easily, pull the print cartridge out of the printer and insert it again. After that, close the front cover again.