Skip header
Help
 

Top Page > Hardware Guide > Guide to the Printer > Exterior: Rear View

Exterior: Rear View

Printer illustration numbered callout illustration

  1. Rear Cover

    Open this cover to replace the fusing unit.

  2. Power Connector

    Connect the power cord to the printer here. Insert the other end of the cable into a nearby wall outlet.

  3. Controller Board

    Slide this out to install options such as the SDRAM module or printer hard disk. Plug cables such as a USB cable and Ethernet cable into their connectors.

  4. Vents

    To prevent overheating, heat from internal components is released through these vents. Malfunctions and failure can result if these vents are blocked or obstructed.

  5. SD Card Slots

    Remove the cover and install SD cards here.

  6. Optional Interface Board Slot

    Insert an optional Wireless LAN interface unit, Gigabit Ethernet board, or 1284 interface board in this slot.

  7. Ethernet Port

    Use a network interface cable to connect the printer to the network.

  8. USB Port B

    Use a USB cable to connect the printer to a computer.

  9. USB Port A

    Use a USB cable to connect the optional USB devices such as the authentication card reader.