Skip header
 

Top Page > Using the Copier Function > Making Enlarged or Reduced Copies

Making Enlarged or Reduced Copies

This section describes how to specify the reduction or enlargement ratio for the current job.

Scaling

There are two ways to set the scaling ratio: using a preset ratio or manually specifying a customized ratio.

  • Preset ratio

    Illustration of Preset ratio

    region-a

    50%, 71%, 82%, 93%, 122%, 141%, 200%, 400%

    region-b

    50%, 65%, 78%, 93%, 129%, 155%, 200%, 400%

  • Custom ratio

    Illustration of Custom ratio

    25% to 400% in 1% increments.

Use this procedure to specify the reduction or enlargement ratio for the current job.

1Press the [Reduce/Enlarge] key.

Reduce/Enlarge key illustration

2Press [Reduce] or [Enlarge], press the [Up arrow key][Down arrow key][Left arrow key][Right arrow key] keys to select the desired ratio, and then press the [OK] key.

3If [Zoom] has been selected, specify the desired ratio using the number keys, and then press the [OK] key.

Note

  • You can press the [Escape] key to exit to the previous level of the menu tree.

  • You can change the machine's default [Reduce/Enlarge] setting to always make photocopies in the specified ratio.

  • Temporary job settings are cleared in the following cases:

    • When no input is received for the period of time specified in [System Auto Reset Timer] while the initial screen is displayed.

    • When the [Clear/Stop] key is pressed while the initial screen is displayed.

    • When the machine's mode is changed.

    • When the power is turned off.

    • When the machine's default for the same setting is changed.

Reference