Skip header
 

Booklet Finisher

This section describes how to remove punch waste from Booklet Finisher.

1Open the finisher front cover.

Finisher illustration

2Pull out the punch waste box carefully, and then remove punch waste.

Punch waste box illustration

3Reinstall the punch waste box.

Punch waste box illustration

4Close the finisher front cover.

Hole Punch Receptacle is full.” disappears.

Note

  • The message Hole Punch Receptacle is full.” may appear even when the punch waste box is not yet full. If this happens, the position of the punch waste box (indicated by the arrow as shown) may be blocked by punch waste. Remove punch waste.

    Punch waste box illustration