Skip header
ManualsContentsPreviousNextHelp

Top Page > PostScript 3 Supplement > Windows Configuration > Using the SmartDeviceMonitor for Client Port > Installing the PostScript 3 Printer Driver (Windows XP, Windows Server 2003 / 2003 R2 - IPP)

Installing the PostScript 3 Printer Driver (Windows XP, Windows Server 2003 / 2003 R2 - IPP)

This section explains how to install the PostScript 3 printer driver under Windows XP or Windows Server 2003 /2003 R2 for use on the SmartDeviceMonitor for Client port.

Important

  1. Quit all applications currently running.

  2. Insert the CD-ROM into the CD-ROM drive.

    The installer starts.

  3. Select an interface language, and then click [OK].

    The printer driver with the selected language will be installed. The English printer driver is installed when the following language is selected: Suomi, Magyar, Cestina, Polski, Portugues, Russian, Catala, Turkce.

  4. Click [PostScript 3 Printer Driver].

    Add Printer Wizard starts.

  5. Click [Next >].

  6. Click [Local printer attached to this computer], and then click [Next >].

  7. Click [Create a new port:].

  8. Click [SmartDeviceMonitor] in [Type of port:], and then click [Next >].

  9. Click [IPP].

  10. In the [Printer URL] box, enter "http://(machine's IP address or host name)/printer" as the machine's address.

    If the server authentication is issued, to enable SSL (a protocol for encrypted communication), enter "https://(machine's IP address or host name)/printer" (Internet Explorer 5.01, or a higher version must be installed).

    (example IP address: 192.168.15.16)

    http://192.168.15.16/printer

    https://192.168.15.16/printer

    You can enter "http://machine's IP address or host name/ipp" as the machine's address.

    If the address is "192.168.001.010", you must enter it as "192.168.1.10" to connect to the machine.

  11. Enter a name for identifying the machine in [IPP Port Name]. Use a name different from the one of any existing port.

    If a name is not specified here, the address entered in the [Printer URL] box becomes the IPP port name.

  12. Click [Detailed Settings] to make necessary settings, and then click [OK].

    For information about the settings, see SmartDeviceMonitor for Client Help.

  13. Click [OK].

  14. Check that the name of the printer driver you want to install is selected, and then click [OK].

  15. Change the name of the machine if you want, and then click [Next >].

    Select [Yes] to configure the machine as default.

  16. Specify whether or not to share the machine, and then click [Next >].

  17. Specify whether or not to print a test page, and then click [Next >].

  18. Click [Finish].

    If the [Hardware Installation] message appears, click [Continue Anyway].

    The printer driver installation starts.

Note

TopPreviousNext
Copyright (C) 2011