Use the "authfree" command to view and configure authfree parameters.
View settings
The following command displays the current authfree settings:
msh> authfree
IPv4/IPv6 configuration display
msh> authfree "ID"
IPv4 address configuration display
msh> authfree "ID" range
IPv6 address configuration display
msh> authfree "ID" range6
IPv6 address mask configuration display
msh> authfree "ID" mask6
IPv4 address configuration
msh> authfree "ID" range_addr1 range_addr2
IPv6 address configuration
msh> authfree "ID" range6_addr1 range6_addr2
IPv6 address mask configuration
msh> authfree "ID" mask6_addr1 masklen
Parallel/USB configuration
msh> authfree [parallel | usb] [on|off]
To enable authfree, set to on. To disable authfree, set to off. Always specify the interface.
Authentication exclusion control initialization
msh> authfree flush
If print job authentication exclusion is not set, authentication exclusion control cannot be displayed.