Loading Paper into Trays 1 - 4

This section describes how to load paper into trays 1 4.

Each paper tray is loaded in the same way.

In the following example procedure, paper is loaded in tray 2.

Check that paper in the paper tray is not being used, and then pull the tray carefully out until it stops.
While pinching the release lever, slide the end fence outward.
Square the paper and load it print side up.
Do not stack paper over the limit mark.
Position the end fence flush against the paper.
Carefully push the paper tray fully in.

When loading a low number of sheets, be sure not to squeeze the side fences in too tightly. If the paper bows, it might not feed in properly.
If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side fences may slip out of place.
Various sizes of paper can be loaded in the paper trays by adjusting the positions of side fences and end fence. For details, see “Changing the Paper Size”.
Tray 1 can hold up to 500 sheets, and trays 2 4 can each hold up to 550 sheets.