ManualsContentsPreviousNext |
This section introduces the names and functions of the components.
Do not obstruct the ventilation holes by placing objects near them or leaning things against them. If the machine overheats, a fault might occur.
Front and left view
Exposure glass cover (optional) or ADF (optional)
(The illustration shows the ADF.)
Lower the exposure glass cover or the ADF over originals placed on the exposure glass.
If you load a stack of originals in the ADF, the ADF will automatically feed the originals one by one. This ADF can be used for two-sided originals.
Ventilation holes
Prevent overheating.
Main power switch
If the machine does not operate after turning on the operation switch, check if the main power switch is turned on. If it is off, turn it on. See “Turning On/Off the Power”.
Exposure glass
Place originals face down here.
Control panel
See “Control Panel”.
Internal tray 1
Copied/printed paper and fax messages are delivered here.
Front cover
Open to access the inside of the machine.
Paper trays (trays 1 2)
Load paper here.
Lower paper trays (optional)
Load paper here.
Operation switch
Press to turn the power on (the operation switch indicator lights up). To turn the power off, press again (the operation switch indicator goes off). See “Turning On/Off the Power”.
Front and right view
Ventilation holes
Prevent overheating.
Right cover
To remove paper jams or use the envelope lever, open this cover.
Envelope lever
To load envelopes in tray 1 or the bypass tray, push down this lever.
Bypass tray
Use to copy or print on OHP transparencies, label paper (adhesive labels), envelopes and custom size paper.
Extender
Pull this extender out when loading sheets larger than A4 in the bypass tray.
Lower right cover
Open this cover when a paper jam occurs.
Rear and left view
Ventilation holes
Prevent overheating.