Setup

Use the following procedure to make network environment settings.

Enable TCP/IP using the control panel, and then set up the printer's network environment about TCP/IP including IP addresses.
TCP/IP of the printer is set as default.
Install a TCP/IP in Windows to set up the network environment.
Consult the network administrator for the local setting information.
To print, install “Printing service for UNIX” as the network application.

For details about setting an IP address, see Hardware Guide.
For details about setting an IP address of the printer using DHCP, see Using DHCP.
This completes the setup for specifying a printer using an IPv4 address when printing. When using a host name to specify a printer, proceed to Using a Host Name Instead of an IPv4 Address and continue the setup.