Skip header
Help
 

Connecting to the Ethernet Interface Region B icon(mainly North America)

This section describes how to connect an Ethernet cable to the Ethernet interface.

Important

  • If the main power switch is on, turn it off.

  • Use the following Ethernet cables.

    • Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type 5 or more

1Make sure the main power is switched off.

2Connect the Ethernet interface cable to the 10BASE-T/100BASE-TX port.

Main unit illustration

3Connect the other end of the Ethernet interface cable to a network connection device such as a hub.

4Turn on the main power switch of the machine.

10BASE-T/100BASE-TX port illustration (numbered callout illustration)

  1. Indicators

    When 100BASE-TX or 10BASE-T is operating, the green LED is lit and the orange LED flashes. If the machine is not connected to the network, both LEDs are turned off.

Note

  • For details about how to turn on the main power switch, see “Turning On/Off the Power”.

  • For details about installing the printer driver, see "Preparing the Machine", Printer Reference.