Skip header
Help
 

Programming/Changing Information Boxes

This section describes how to set up an Information Box.

You can store the following items:

1Press [Facsimile Features].

2Press [General Settings].

3Press [Box Setting].

4Check that [Program / Change] is selected.

5Select the box to program.

When programming a new box, press [Not Programmed].

Operation panel screen illustration

To change a box already programmed, press it, and then proceed to step 8. If a password is programmed, enter the password, press [OK], and then proceed to step 8.

6Press [Information Box].

7Enter a box name, and then press [OK].

8Enter the SEP Code.

Operation panel screen illustration

To change the SEP Code, press [Clear], and then try again. To change the box name, press [Box Name], and then repeat the procedure from step 7.

9Press [Password].

If you do not want to program a password, proceed to step 12.

10Enter a password, and then press [OK].

Operation panel screen illustration

If you make a mistake, press [Clear] before pressing [OK], and then try again.

11Re-enter the password, and then press [OK].

If you make a mistake, press [Clear] before pressing [OK], and then try again.

To change the password after pressing [OK], press [Password] and repeat steps 10 and 11, or press [Cancel] and repeat from step 9.

12Press [OK].

13Press [Exit].

14Press the [User Tools/Counter] key.

Note

  • You can edit boxes in the same way you program them. However, boxes that are being used cannot be edited.