Skip header
 

Installing Device Certificate

1Log in to Web Image Monitor as an administrator.

2In the menu area, click [Configuration].

3Under "Security", click [Device Certificate].

4Click [Certificate 2] on the "Device Certificate" window, and then click [Request].

5Enter appropriate "Common Name" and "Country Code" on "Certificate Information" page, and then click [OK].

6"Updating..." appears. Wait for about 2 minutes, and then click [OK].

7Click [Details], shown in the "Device Certificate" window as the memo pad icon for "Requesting".

8Select all, and then copy the entire "Text for Requested Certificate" text that is displayed in the "Certificate Status" window.

9Access the certificate authority server, and then obtain the CA signified certificate using the text copied into "Text for Requested Certificate" windows.

Obtaining the certificate differs depending on the environment you want to use.

10Click [Certificate 2] on "Device Certificate" window, and then click [Install].

11Using a text editor, open the CA signified certificate downloaded in step 9, and then copy over all the text.

12In the [Enter Certificate Request] window, paste all the text copied into the CA signified certificate.

13Click [OK].

14"Updating..." appears. Wait for about one or two minutes, and then click [OK].

15Check that the "Device Certificate" shows "Installed".

16Click [Certificate 2] on "Certification", and then click [OK].

17Click [Logout].

18Quit Web Image Monitor.

Note

  • If you request two certificates simultaneously, the certificate authority might not display either certificate. Click [Cancel Request] to cancel the request.

  • You can select [Certificate 1-4] in the "Device Certificate" window. Note that if you select [Certificate 1] in the "Device Certificate" window, you must select "Certificate 1" in the "IEEE 802.1X" drop down menu in the "Certification" window.

  • Click [Cancel Request] to cancel the request for the server certificate.

  • If "Not found" appears after clicking [OK] in steps 6 and 14, wait one or two minutes, and then click [Refresh].