Interrupt Copy

Use this function if you want to interrupt a long copy job to make urgently needed copies.

You cannot use the Staple function with this function if another copy job is already using the Staple function.

Press the [Interrupt] key.
The interrupt key indicator lights.
Remove the originals that were being copied.
Place the originals you want to copy.
Press the [Start] key.
When copying is complete, remove the originals and copies.
Press the [Interrupt] key again.
The interrupt key indicator goes off.
Place the originals that you copied before, and then press the [Start] key.
Following the instructions on the display.

The previous copy job settings are restored. Simply press the [Start] key to continue copying from where it left off.