Top Page > About This Machine > Remarks > Where to Put Your Machine > Power Connection
Power Connection
![WARNING](../../web/gen/en-warning.gif)
|
Do not use power cords that are damaged, broken, or modified. Also, do not use power cords that have been trapped under heavy objects, pulled hard, or bent severely. Doing so could result in fire or electric shock.
|
![WARNING](../../web/gen/en-warning.gif)
|
If the power cord is damaged (exposure of the core, disconnection, etc.), contact your service representative to change a new one. Operating the machine with a damaged power cord may cause an electric shock or fire.
|
![WARNING](../../web/gen/en-warning.gif)
|
When this machine's circuit breaker is set to "Off", do not switch it to "On". Doing so could result in electric shock, fire, smoke, or tripping of the room's breakers.
|
![CAUTION](../../web/gen/en-caution.gif)
|
When disconnecting the power cord from the wall outlet, always pull the plug, not the cord. Pulling the cord can damage the power cord. Use of damaged power cords could result in fire or electric shock.
|
Make sure the plug is inserted firmly in the wall outlet.
Voltage must not fluctuate by more than 10%.
Power Source
208
240 V, 20 A or more, 50/60 Hz
Please be sure to connect the power cord to a power source as above.