Erase Outside
Use this function to copy the original while erasing outside of a specified area.
To specify the area you want to erase, you must define the positions where the machine starts scanning (X1, Y1) and where it stops scanning (X2, Y2) on the original. Measure the area you want to specify before entering the area settings.
X1, X2: 0 
432 mm (0 17 inches)
Y1, Y2: 0 432 mm (0 17 inches)
Press [Edit / Color].
Press [Erase].
Press [Erase Outside].
Enter the length of [X1] with the number keys, and then press [
].
Enter the length of [Y1] with the number keys, and then press [].
Enter the length of [X2] with the number keys, and then press [].
Enter the length of [Y2] with the number keys, and then press [].
If you want to erase the image on the back side of the original, press [2 Sided Setting] and then [Back Side].
Erasing the image on the back side is valid when you copy 2-Sided originals.
Press [OK] twice.
To change the value you entered, press the key you want to change, and then enter a new value.
