Skip header
 

Configuring IEEE 802.1X

IEEE 802.1X can be configured using Web Image Monitor's administrator mode. You can select four types of EAP authentication method: EAP-TLS, LEAP, EAP-TTLS and PEAP. Note that each EAP authentication method has different configuration settings and authentication procedures.

Types and requirements of certificates are as follows:

If a certificate is required, configure all settings after installing the certificate.

EAP Types Requiring a “Site Certificate”

EAP-TLS, EAP-TTLS, PEAP (Necessary except LEAP)

EAP Types Requiring a “Site Certificate” and a “Device Certificate”

EAP-TLS, PEAP (Phase 2 is for TLS only)

Important

  • To set IEEE 802.1X, you must enable SSL. For details about setting SSL configuration, see “Protection Using Encryption”, Security Reference.

  • To set IEEE 802.1X, you must use Web Image Monitor.