Skip header
 

Changing the User Parameters

This section describes how to set parameters.

Important

  • Access to some User Parameter Setting may require options, or other settings may need to be made beforehand.

  • It is recommended that you print and store the “Parameter Settings List” when you program or change parameter settings.

  • Do not change any bit switches other than those shown on the previous pages.

1Select [Fax Features] using [Up arrow key] or [Down arrow key], and then press the [OK] key.

Operation panel screen illustration

2Select [Administrator Tools] using [Up arrow key] or [Down arrow key], and then press the [OK] key.

Operation panel screen illustration

3Select [Parameter Setting] using [Up arrow key] or [Down arrow key], and then press the [OK] key.

Operation panel screen illustration

4Select [Parameter Setting] using [Up arrow key] or [Down arrow key], and then press the [OK] key.

Operation panel screen illustration

5Select the switch number you want to change using the scroll keys, and then press the [OK] key.

Operation panel screen illustration

6Select the bit number you want to change.

Operation panel screen illustration

When the bit number is pressed, the current value switches between 1 and 0.

Repeat step 6 to change another bit number for the same switch.

7Press the [OK] key.

Operation panel screen illustration

8Repeat steps 5 through 7 to change the switch settings.

9After all the settings are finished, press the [User Tools/Counter] key.

Operation panel screen illustration

Note

  • For details about how to print parameter settings list, see “Printing the Parameter Settings List”.