Skip header
 

Basic Procedure for Saving Scan Files on a Removable Memory Device

Use the following procedure to save scan files on a removable memory device.

1Insert a removable memory device in the media slot.

You can connect only one removable memory device at a time.

2Close the media slot cover.

If you leave the cover open, static electricity conducted through an inserted SD card could cause the machine to malfunction.

3Make sure that no previous settings remain.

If a previous setting remains, press the [Clear Modes] key.

4Place originals.

5Press [Options], to select [Output Method], and then press the [OK] key.

Operation panel screen illustration

6Select [Store to Memory Device], and then press the [OK] key.

Operation panel screen illustration

7Press the [Escape] key.

Operation panel screen illustration

8Press [Options], to select [Send Options], and then press the [OK] key.

For details, see "Specifying Send Options".

9If necessary, select the original type.

For details, see "Selecting Original Type".

10If necessary, specify the scanning density.

For details, see "Adjusting Image Density".

11Press the [Start] key.

When writing is complete, a confirmation message appears.

12Press [Exit].

13Remove the memory device from the media slot.

Do not remove the memory device while writing is in process. Doing so can corrupt the data that is stored on it.

Note

  • You cannot specify where the data is saved. Files are saved in the root directory of the removable memory device.

  • Up to 2 GB of data can be saved. However, depending on the number of files already stored on the removable memory device, new files might not be saved, even if there appears to be sufficient free space.

  • If the removable memory device is partitioned, files are saved on the first partition.

  • To cancel writing, press the [Clear/Stop] key. If files are being written when writing is cancelled, any partially written files are deleted. Only complete files are stored on the removable memory device.

  • The LED lamp on the media slot flashes when an inserted SD card is being accessed and remains lit when a USB memory stick is attached.