Confirming Transmission Results by E-mail
Use this function to confirm the transmission results by sending an e-mail notification to the specified destination.
Register the e-mail address of the destination for e-mail notification in the destination list in advance.
Place the original, and then select the scan settings you require.
Specify the sender.
For details, see “Sender Settings”.
Press [TX Mode].
Press [E-mail TX Results].
Select the destination of notification, and then press [OK].
If you make a mistake, before pressing [OK], press [Clear] or press the selected Destination key again to turn the highlight off.
[E-mail TX Results] gets highlighted and the destination of notification selected appears.
Press [OK].
The standby display appears.
To check the settings, press [TX Mode].
Specify a destination, and then press the [Start] key.
You can program one of the Quick Operation keys with operations for this function. Using the Quick Operation Key allows you to omit steps 3 and 6. For details about Quick Operation Key, see “General Settings”.
