This section describes how to change the paper size in the lower paper tray or the lower paper trays.
If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side fences may slip out of place.
Check the paper edges are aligned with the right side.
Slide the side fences until they are aligned with the paper size, and then re-lock the side fences.
Check that paper in the paper tray is not being used, and then pull the tray carefully out until it stops.
Remove paper if loaded.
Release the lock on the side fences.
Square the paper and load it print side up.
Do not stack paper over the limit mark.
While pressing down the release lever, slide the side fences until they are aligned with the loaded paper size.
Make sure there are no gaps between the paper and side fences.
Slide the end fence until it is aligned with the loaded paper size.
Make sure there are no gaps between the paper and end fence.
Re-lock the side fences again.
Carefully slide the paper tray fully in.
Check the size on the display.
If you load a paper size that is not selected automatically, you will need to specify the paper size with the control panel. For details, see “Changing to a Size That Is Not Automatically Detected”.