This section describes the user tools in the Input / Output menu under Copier / Document Server Features.
Switch to Batch
You can select to have Batch mode or SADF mode displayed when you press [Special Original].
SADF Auto Reset
In SADF mode, an original must be set within a specified time after the previous original has been fed.
Default: [5 seconds]
You can adjust this time from 3 to 99 seconds in increments of 1 second.
Rotate Sort: Auto Paper Continue
Specify whether or not the machine continues copying when paper of the required orientation runs out during rotate sort.
Copying continues using copy paper of a different orientation. The copy job will finish even if you have left the machine.
When paper of the required orientation runs out, the machine stops copying and prompts you to supply copy paper. After you have loaded paper, the machine will continue copying.
Memory Full Auto Scan Restart
When memory becomes full while scanning originals, the machine can make copies of scanned originals first, and then automatically proceed scanning remaining originals.
You can leave the machine unattended to make copies, but sorted pages will not be sequential.
When memory becomes full, the machine stops operation allowing you to remove the copy pages delivered on the output tray.
If you select [Yes] in this function, the machine rotates the image correctly.
Orientation-fixed (top to bottom) or two-sided paper might not be printed correctly depending on how the originals and paper are placed.
Specify which staple type has priority to be shown on the initial display.
Default for “Staple Position 1”: [Staple: Top 1]
Default for “Staple Position 2”: [Staple: Bottom 1]
Default for “Staple Position 3”: [Staple: Left 2]
Default for “Staple Position 4”: [Staple: Top 2]
Specify which punch type has priority to be shown on the initial display.
Default for “Punch Type 1”: [Punch: 3 Holes Left]
Default for “Punch Type 2”: [Punch: 3 Holes Top]
Simplified Screen: Finishing Types
You can select which key is displayed with higher priority for “Finishing Types” on the Simplified Screen.
Default for “Simplified Screen: Finishing Types 1“: [Do not Display]
Default for “Simplified Screen: Finishing Types 2“: [Do not Display]
Default for “Simplified Screen: Finishing Types 3“: [Do not Display]