Replacing the Waste Toner Bottle

Do not incinerate toner (new or used) or toner containers. Doing so risks burns. Toner will ignite on contact with naked flame.

Keep the polythene materials (bags, gloves, etc.) supplied with this machine away from babies and small children at all times. Suffocation can result if polythene materials are brought into contact with the mouth or nose.

Wait for 30 minutes or more after disconnecting the power plug before removing the paper transfer unit.

The inside of the machine could be very hot. Do not touch the parts with a label indicating the "hot surface". Otherwise, an injury might occur.

Waste toner bottles cannot be reused.
Purchasing and storing extra waste toner bottles is recommended.
If the bypass tray is open, close it before pulling out Tray 1.
When removing the waste toner bottle, make sure not to tilt it.
Keep the waste toner bottle horizontal as you take it out.
Make sure that the paper transfer unit is installed. If the paper transfer unit is not installed, install it before turning the power on.
Cooperate with the waste toner bottle Recycling Program, whereby used waste toner bottles are collected for recycling.
Before removing the waste toner bottle from the printer, spread paper or some other material around the area to keep toner from dirtying your workspace.

Replace the waste toner bottle if the following message appears on the display:

"Waste Toner Bottle full"

Illustration of message

When the following message appears on the display, the waste toner bottle should be replaced soon. Prepare a new Waste Toner Bottle.

"Waste Toner almost full"

Illustration of message

Pull front cover open lever, and then open the front cover with both hands carefully.
Slide both levers on the front cover outward.
Hold both ends of the paper transfer unit, and then lift it up.
Hold the center of the waste toner bottle, and then carefully pull it out horizontally.
Pull the waste toner bottle halfway out, grab the bottle, and then pull it straight out.
To prevent the waste toner bottle touching the intermediate transfer unit, do not lift the bottle while pulling it out.
Close the bottle cap.
Hold the center of the new waste toner bottle, and then carefully insert it halfway into the printer body.
Leave the cap open.
To prevent the waste toner bottle touching the intermediate transfer unit, do not lift the bottle while inserting it.
Push in the waste toner bottle until it clicks into place.
Push the green part all the way in.
Place the paper transfer unit on the front cover by aligning the mark on the paper transfer unit with the mark on the front cover.
Then, push on the green PUSH marks until the paper transfer unit clicks into place.
Close the front cover with both hands carefully.