Skip header
 

Top Page > Hardware Guide > Appendix > Moving and Transporting the Printer

Moving and Transporting the Printer

WARNING

  • If the machine topples, or if a cover or other part gets broken, you must turn the power switch to off and disconnect the power cord plug from the wall outlet. Then contact your service representative and report the problem. Do not use the machine. Doing so could result in fire or electric shock.

CAUTION

  • The printer weighs approximately 29 kg (64.0 lb.). When moving the printer, use the inset grips on both sides, and lift slowly in pairs. The printer will break or cause injury if dropped.

CAUTION

  • When disconnecting the power cord from the wall outlet, always pull the plug, not the cord. Pulling the cord can damage the power cord. Use of damaged power cords could result in fire or electric shock.

CAUTION

  • Unplug the power cord from the wall outlet before you move the machine. While moving the machine, take care that the power cord is not damaged under the machine. Failing to take these precautions could result in fire or electric shock.

CAUTION

  • When moving the printer after use, do not take out any of the toners, nor the waste toner bottle to prevent toner spill inside the printer.

Important

  • Be sure to disconnect all cables from the printer before transporting it.

  • The printer is a piece of precision machinery. Take care to avoid damage during transportation.

  • If optional paper feed units are attached, remove them from the printer and move them separately.

Repack the printer using its original packaging for transporting.

Note

  • The printer weighs approximately 29 kg (64.0 lb.).

Related topics

Moving the Printer in a Short Distance