Skip header
 

Printer Does Not Print

Is the power on?

Confirm that the cable is securely plugged into both the power outlet and the printer.

Turn on the power.

Does the Alert indicator stay red?

If so, check the error message on the display and take the required action.

For details, see Error and Status Messages Appear on the Control Panel.

Is paper loaded?

Load paper into the paper tray or onto the bypass tray.

For details, see Loading Paper in Trays.

Can you print a configuration page?

If you cannot print a configuration page, it probably indicates a printer malfunction. Contact your sales or service representative.

For details, see Test Printing.

Is the interface cable connected securely to the printer and the computer?

Connect the interface cable securely. If it has a fastener, fasten it securely as well.

Are you using the correct interface cable?

The type of interface cable you should use depends on the computer you use. Be sure to use the correct one.

If the cable is damaged or worn, replace it with a new one.

For details, see Specifications.

Is the Data In indicator blinking or lit after starting a print job?

If not blinking or lit, the data is not being sent to the printer.

  • If the printer is connected to the computer using the interface cable

    Check the port connection setting is correct. For details about checking the port connection, see Checking the Port Connection.

  • Network Connection

    Consult your network administrator.

How is the signal strength when using the Wireless LAN?

  • 802.11 Ad hoc Mode

    Either move to a location where the signal is good, or remove obstructions.

  • Infrastructure Mode

    Check the signal status in the [Wireless LAN] menu on the control panel. If the signal is poor, either move to a location where it is good, or remove obstructions.