Loading Envelopes onto Bypass Tray
This section explains how to load envelopes onto the bypass tray and change paper size.
Hold the middle part of the bypass tray and pull it toward you.
Fan envelopes, and then align their edges before loading.
When fanning envelopes, make sure the envelope flaps are not stuck together. If they are stuck together, separate them.
Before loading envelopes, flatten them out so that their curl does not exceed that shown in the illustration below.
If the curl is severe, flatten out the envelopes using your fingers, as shown in the illustration below.
If envelopes are severely curled after printing, flatten them by bending them back against the curl.
Set the envelope in bypass tray with the printing side facing down.
Adjust the paper guide both sides to fit the envelope width.
