Setting WPA

Press the [Menu] key.

Press the [ ] or [ ] key to select [Host Interface], and then press the [OK] key.

Press the [ ] or [ ] key to select [Wireless LAN], and then press the [OK] key.

Press the [ ] or [ ] key to select [Security Method], and then press the [OK] key.

Press the [ ] or [ ] key to select [WPA], and then press [Details].

Press the [ ] or [ ] key to select [Encryption Method], and then press the [OK] key.

Press the [ ] or [ ] key to select encryption method, and then press the [OK] key.

Consult your network administrator for information about making encryption settings.

Encryption settings are as follows:

• [TKIP]

  Uses the same algorithm as RC4, but further reduces vulnerability using methods such as key mixing.

• [CCMP(AES)]

  Increases security using AES (Advanced Encryption Standard).

The display returns to the [WPA] menu.

Press the [ ] or [ ] key to select [Authentication Method], and then press the [OK] key.

Press the [ ] or [ ] key to select authentication settings, and then press the [OK] key.

Authentication settings are as follows:

• [WPA-PSK]

  Performs authentication using an encryption key (a Pre-Shared Key) that is shared by the access point and client.

• [WPA]

  WPA uses CA certificates and a RADIUS server to provide secure wireless communication.

• [WPA2-PSK]

  As with WPA-PSK, authenticate using the encryption key (a Pre-Shared Key) shared by the access point and client. Enter Pre-Shared Key using between 8 and 63 ASCII characters.

• [WPA2]

  WPA2 is an expanded version of WPA that fully supports IEEE 802.11i.

Wait for two seconds, the display returns to the [WPA] menu.

If [WPA] or [WPA2] is selected in step 9, a confirmation message appears. Press [OK].

Wait for two seconds. The display returns to the [WPA] menu, proceed to step 15.

If [WPA-PSK] or [WPA2-PSK] is selected in step 9, a confirmation message appears. Press [Enter].

Enter the Pre-Shared Key, and then press [Accept].

• When entering a character, pressing [OK] will mask it with an asterisk for security reasons.

• Enter the Pre-Shared Key using between 8 and 63 ASCII characters.

• Uppercase and lowercase letters are differentiated, so be sure to enter characters in the required case.

• Wait for two seconds. The display returns to the [Authentication Method] menu.

Press the [Escape] key.

Press [Exit].

Press the [ ] or [ ] key to select [WPA], and then press the [OK] key.

Press the [Menu] key to return to the initial screen.

Print a configuration page to confirm the settings.