Skip header
 

Top Page > Hardware Guide > Setting Up the Printer > Unpacking

Unpacking

To protect it from shock and vibration during transit, this printer comes packaged in cushioning foam and secured with tape. Remove these protective materials after bringing the machine to where it will be installed.

WARNING

  • Keep the polythene materials (bags, etc.) supplied with this machine away from babies and small children at all times. Suffocation can result if polythene materials are brought into contact with the mouth or nose.

WARNING

  • Do not incinerate toner (new or used) or toner containers. Doing so risks burns. Toner will ignite on contact with naked flame.

CAUTION

  • Do not crush or squeeze toner containers. Doing so can cause toner spillage, possibly resulting in dirtying of skin, clothing, and floor, and accidental ingestion.

CAUTION

  • Keep toner (used or unused) and toner containers out of reach of children.

CAUTION

  • If toner or used toner is inhaled, gargle with plenty of water and move into a fresh air environment. Consult a doctor if necessary.

CAUTION

  • If toner or used toner gets into your eyes, flush immediately with large amounts of water. Consult a doctor if necessary.

CAUTION

  • If toner or used toner is swallowed, dilute by drinking a large amount of water. Consult a doctor if necessary.

CAUTION

  • Be careful not to trap your fingers when opening or closing the top cover.

CAUTION

  • When lifting the machine, use the inset grips on both sides. The printer could break or cause an injury if dropped.

Important

  • Removed tape is dirty. Be careful not to let it touch your hands or clothes.

  • Do not grip on the tray area when lifting the printer.

  • Do not allow paper clips, staples, or other small metallic objects to fall inside the printer.

  • Keep the uncovered print cartridge away from direct sunlight.

  • When you use this printer for the first time, use the four print cartridges supplied with the printer.

Note

  • Print cartridge (consumables) are not covered by warranty. However, if there is problem, contact the store where they were purchased.

1Remove the plastic bag.

2Lift the printer with two people by using the inset grips on both sides of the printer.

Leave the tape holding the paper feed tray and cover in place while moving the printer. Lower the machine slowly and carefully to prevent trapping your hands.

Printer illustration

When moving the printer, do not hold on the following parts as doing so could cause a malfunction:

  • The handle onto the standard paper feed tray.

  • The underside of the bypass tray.

3Remove the adhesive tape.

4Pull up top cover open lever to open the top cover.

Printer illustration

5Remove the adhesive tape.

Printer illustration

Printer illustration

6Take each print cartridge out.

Gripping its center, carefully pull the print cartridge upward and out.

Printer illustration

When taking out the black print cartridge, be sure to place it on at a flat surface, and then remove the protection sheet also.

Print cartridge illustration

Do not touch the print cartridge's photo conductor unit.

Print cartridge illustration

Do not touch a metal part.

Print cartridge illustration

7Hold the print cartridge and shake it from side to side five or six times.

Print cartridge illustration

8Check the toner color and location correspond, and then carefully insert the print cartridge vertically.

Printer illustration

9Close the top cover with both hands carefully. Be careful not to trap your fingers.

Printer illustration