Skip headerimage
ManualsContentsPreviousNextHelp

Programming Initial Set Up of a Special Sender

This section describes how to program Initial Set Up of a Special Sender.

Program the “Initial Set Up” of a Special Sender. You can also specify the Bypass Tray Paper Size.

  1. Press [Facsimile Features].

  2. Press [Reception Settings].

  3. Press [Program Special Sender].

  4. Press [Initial Set Up].

    Operation panel screen illustration

  5. Select the function you want to program.

    Operation panel screen illustration

  6. To program Authorized Reception and Special Reception Function, press [Authorized Reception] or [Special Reception Function].

  7. Press [On] or [Off], and then press [OK].

    The illustration shows the “Authorized Reception” display as an example.

    Operation panel screen illustration

  8. To program Bypass Tray Paper Size, press [Bypass Tray Paper Size].

  9. Select the size you want to program.

    You can select a size from [Auto Detect], [Regular Size], or [Custom Size].

    If you select [Auto Detect], proceed to step 14.

    If you select [Regular Size], proceed to step 10.

    If you select [Custom Size], proceed to step 11.

  10. Select the size you want to program from the sizes shown.

    Operation panel screen illustration

    After selecting the size, proceed to step 14.

  11. Make sure that [Vertical] is selected.

  12. Enter the vertical size of the paper using the number keys, and then press the [Sharp] key.

    Operation panel screen illustration

    Specify a vertical size from 70 mm (2.8 inches) to 216 mm (8.5 inches).

    Each time you press [mm] or [inch], the units switch between “mm” and “inch”.

    If you enter a length and change the units by pressing [mm] or [inch], it is converted automatically (fractions are rounded off).

  13. Enter the horizontal size of the paper using the number keys, and then press the [Sharp] key.

    Operation panel screen illustration

    Specify a horizontal size from 127 mm (5.0 inches) to 600 mm (23.6 inches).

    Each time you press [mm] or [inch], the units switch between “mm” and “inch”.

    If you enter a length and change the units by pressing [mm] or [inch], it is converted automatically (fractions are rounded off).

  14. Press [OK].

  15. Press [Exit].

  16. Press the [User Tools/Counter] key.

Note