Skip headerimage
ManualsContentsPreviousNextHelp

Changing the Paper Size in Trays 1 - 4

This section describes how to change the paper size in trays 1 hyphen 4.

The paper size setting is changed in the same way for trays 1 hyphen 4.

In the following example procedure, the paper size setting for tray 1 is changed.

Important

Various sizes of paper can be loaded in trays 1 hyphen 4 by adjusting the positions of the side fences and end fence.

  1. Check that paper in tray 1 is not being used, and then pull tray 1 carefully out until it stops.

    Tray 1 illustration

  2. Remove paper if loaded.

  3. Release the lock on the side fences.

    Tray 1 illustration

  4. While pressing down the release lever, slide the side fences outward.

    Tray 1 illustration

  5. Pinch the release levers of the end fence, and then slide the end fence outward.

    Tray 1 illustration

  6. Square the paper and load it print side up.

    Do not stack paper over the limit mark.

    Tray 1 illustration

  7. Align the back and side fences gently against the paper you loaded.

    Tray 1 illustration

  8. Re-lock the side fences.

  9. Carefully slide tray 1 fully in.

  10. Check the paper size on the display.

Note

Reference