This section introduces the names and functions of the components.
Do not obstruct the ventilation holes by placing objects near them or leaning things against them. If the machine overheats, a fault might occur.
Front and left view
ADF
Lower the ADF over originals placed on the exposure glass.
If you load a stack of originals in the ADF, the ADF will automatically feed the originals one by one. This ADF can be used for two-sided originals.
Exposure glass
Place originals face down here.
Main power switch
If the machine does not operate after turning on the operation switch, check if the main power switch is turned on. If it is off, turn it on. See “Turning On/Off the Power”.
Ventilation holes
Prevent the machine from overheating.
Operation switch
Press to turn the power on (the operation switch indicator lights up). To turn the power off, press again (the operation switch indicator goes off). See “Turning On/Off the Power”.
Control panel
See “Control Panel”.
Finisher (types 2 and 4 only)
Sorts, stacks, and staples multiple sheets of paper.
Internal tray 1 (types 1 and 3 only)/ Finisher shift tray (types 2 and 4 only)
Copied/printed paper and fax messages are delivered here.
Front cover
Open to access the inside of the machine.
Tray 1
Load paper here print side up.
Lower paper tray (optional)
Load paper here print side up.
Lower paper trays (optional)
Load paper here print side up.
Rear and right view
Right tray (optional)
Printed paper is delivered print face down.
Upper right cover
Open this cover to remove misfed paper.
Duplex unit
Open this cover to remove misfed paper.
Tray 2 right cover (optional)
Open this cover to remove misfed paper.
Lower right cover (optional)
Open this cover to remove misfed paper.
Ventilation holes
Prevent the machine from overheating.
Bypass tray
Use to print onto plain paper, thick paper, OHP transparencies, and custom size paper.
Extender
Pull this extender out when loading A4 or larger size paper in the bypass tray.