Skip headerimage
ManualsContentsPreviousNextHelp

Registering and Changing Keystroke Programs

This section explains how to program a new Keystroke Program or overwrite an old one.

You can register the following items in Keystroke Programs:

The following procedure explains using Send Later with the fax number “0123456789” as an example of how to register a program.

  1. Make sure that the machine is in facsimile mode and the standby display is shown.

    If the standby display is not shown, press the [Facsimile] key.

  2. Make the settings you want to register in the program.

    The procedure for programming differs depending on the items you want to register.

    Press the [Clear Modes] key to cancel programming.

    Press the number keys [0], [1], [2], [3], [4], [5], [6], [7], [8], [9], and then continue doing the Send Later setting until the standby display appears when you press [OK].

  3. Press the [Program] key.

    Program key illustration

  4. Press [Program].

    When no programs are registered, proceed to step 5.

    Operation panel screen illustration

  5. Select a program number in which “Not Programmed” is shown.

    Operation panel screen illustration

    If you make a mistake, press [Cancel] and select a program number again.

    When you change a Keystroke Program, press [Yes] after pressing the program number you want to change. If you make a mistake, press [No] and try again.

  6. Enter the program name, and then press [OK].

    The standby display appears.

    If the program name is already registered, the name is displayed. To change the program name, press [], [], [Backspace], or [Delete All], and then try again.

    You should register the program name.

    To cancel a program, press [Cancel]. The display returns to that of step 5.

Note

Reference

Related topics

Changing a program name