Skip headerimage
ManualsContentsPreviousNextHelp

Forwarding per Sender

This section describes how to specify Forwarding.

Specify when programming a Special Sender.

Important

  1. Press [Forwarding per Sender].

  2. Select [On] or [Off].

    If you select [Off], proceed to step 7.

    Operation panel screen illustration

  3. Specify an End Receiver using the destination list, and then press [OK].

    Operation panel screen illustration

    Press the transmission type tab to switch the destination between fax number, Internet Fax destination, e-mail address, and folder destination.

    IP-Fax destination appears in the fax destination list.

  4. Press [Security].

    If not specifying the security function, proceed to step 7.

    Security is set to use S/MIME authentication. For details about the security settings, consult your administrator.

    Operation panel screen illustration

  5. Select the security functions.

    Operation panel screen illustration

    To specify encryption for documents for Forwarding, press [Encryption]. To use the encryption function, the address must be stored in the Address Book and have the encryption option enabled. For details about Encryption, consult your administrator.

    To attach a signature to documents for Forwarding, press [Signature]. For details about Signature, consult your administrator.

  6. Press [OK].

  7. Press [OK].

Note

Reference