Adding Toner

This section describes how to add and store toner.

Do not incinerate toner (new or used) or toner containers. Doing so risks burns. Toner will ignite on contact with naked flame.

Do not store toner (new or used) or toner containers anywhere near naked flames. Doing so risks fire and burns. Toner will ignite on contact with naked flame.

Do not incinerate spilled toner or used toner. Toner dust might ignite when exposed to an open flame.

Do not crush or squeeze toner containers. Doing so can cause toner spillage, possibly resulting in dirtying of skin, clothing, and floor, and accidental ingestion.

If toner or used toner is inhaled, gargle with plenty of water and move into a fresh air environment. Consult a doctor if necessary.

If toner or used toner gets into your eyes, flush immediately with large amounts of water. Consult a doctor if necessary.

If toner or used toner is swallowed, dilute by drinking a large amount of water. Consult a doctor if necessary.

When removing jammed paper or replacing toner, avoid getting toner (new or used) on your clothing. If toner comes into contact with your clothing, wash the stained area with cold water. Hot water will set the toner into the fabric and make removing the stain impossible.

When removing jammed paper or replacing toner, avoid getting toner (new or used) on your skin. If toner comes into contact with your skin, wash the affected area thoroughly with soap and water.

Always add toner when the machine instructs you.
Fault may occur if you use toner other than the recommended type.
When adding toner, do not turn off the operation switch. If you do, settings will be lost.
Store toner where it will not be exposed to direct sunlight, temperatures above 35 °C, or high humidity.
Store toner on a flat surface.

If the message "Check toner cartridge replacement(s)." appears, the toner has almost run out. Have a replacement toner cartridge at hand.
If appears when there is still toner in the cartridge, hold the cartridge with the opening upward, shake it well, and then reinstall it.
You can check the name of the required toner and the replacement procedure using the "Add Toner" screen.
Press [System Status] to check contact number where you can order supplies. See “Checking Machine Status and Settings”, Troubleshooting.
You can add all four color toners in the same way.