Loading Paper into Tray 3 (LCT)

This section describes how to load paper into Tray 3 (LCT).

When paper loaded in the right side of Tray 3 (LCT) runs out, paper on the left is automatically shifted to the right. While the paper is moving, a message instructing you to wait appears. Do not pull out the tray at this time.
For the right stack, align the right edge of the paper with the right edge of the tray. For the left stack, align the left edge of the paper to the left edge of the tray.
Tray 3 (LCT) can hold 8¹/₂ × 11 paper only. If you want to print on A4 from Tray 3 (LCT), contact your service representative.

Carefully pull out Tray 3 (LCT) until it stops.
Square the paper and load it print side up.
Do not stack paper over the limit mark.
- Whole tray pulled out
- Left half of the tray pulled out
Carefully push the paper tray fully in.

You can load paper even while making copies from Tray 3 (LCT). You can pull out the left half of the tray while copying is in.
Load the same size and orientation paper in the other half of the tray.
Each tray can hold up to 1,000 sheets of paper.