Basic Procedure for Saving Scan Files on a Removable Memory Device

Insert a removable memory device in the media slot.

You can connect only one removable memory device at a time. The media slot cannot be used if both an SD card and a USB flash memory are inserted into it at the same time.

Make sure that no previous settings remain.

If a previous setting remains, press the [Clear Modes] key.

Press [Store File].

Press [Store to Memory Device].

Press [OK].

If necessary, press [Scan Settings] to specify scanner settings such as resolution and scan size.

For details, see "Various Scan Settings".

If necessary, specify the scanning density.

For details, see "Adjusting Image Density".

If necessary, press [Next Original Wait].

For details, see "Waiting for Additional Originals".

If necessary, press [Original Feed Type] to configure the original orientation settings.

For details, see "Setting of Original Feed Type".

If necessary, press [Send File Type / Name] to specify settings such as file format and file name.

For details, see "Specifying the File Type and File Name".

Place originals.

If scanning does not start automatically, press the [Start] key.

When scanning batches, place subsequent originals after the scan files have been sent.

When writing is complete, a confirmation message appears.

Press [Exit].

Remove the memory device from the media slot.

Remove the media from the media slot only after data has been written completely. Removing the media while data is being written will result in corrupted data.