ManualsContentsPreviousNext |
The HP-GL/2 filter does not support the following commands for plotter control according to the HP plotter and will ignore them if they are included:
Command |
Description |
---|---|
AP |
Specifies the automatic pen function. |
FS |
Specifies the pen pressure. |
AS |
Specifies the pen acceleration. |
VS |
Specifies the maximum speed when the pen is lowered. |
VA |
Automatically adjusts the speed of the pen when it is lowered to the speed at which the computer sends the coordinates. |
VN |
Used when disabling the VA command. |
GP |
Used when collecting pens of the same type and color into one group. |
SG |
Selects the group specified by the GP command. |
CV |
Controls the curve line generator. |
AF |
Feeds paper only when something is being plotted on the current paper. |
AH |
Feeds half of the paper only when something is being plotted on the current paper. |
EC |
Controls the paper cut function. |
NR |
Puts the plotter into the "NOT READY" state. |
BF |
Stores the HP-GL command following this command to the replot buffer until the RP command is received. |
RP |
Re-plots data using the data in the re-plot buffer. |
WD |
Displays messages on the plotter's front panel LCD, and applies the plotter's keyboard mode. |
KY |
Assigns the programmed status to the plotter's front panel function key. |
OK |
Enables the number of the first pressed front panel function key to be output. |
GC |
Specifies the group count number used in response to the OG command. |
OG |
Enables the current group account information to be output. |
BP |
Sounds the plotter's beeper. |