Skip header
ManualsContentsPreviousNextHelp

Commands for extended character sets

The HP-GL/2 filter supports the following character sets: Standard ASCII (0); kanji (101); and 8, 18, and 43 (katakana). The HP-GL/2 filter does not support the commands for multiple character sets and making optional characters:

Command

Description

CM

Specifies modes for selecting the character set and using it.

DS

Specifies the character set selected by parameter at the character slot.

IV

Calls up the character slot (G0 - G3) on the right half (GR) or left half (GL) of the code table.

CC

Specifies smoothness of characters when the character set when a character set between 10 to 19 and 40 to 49 is selected.

UC

Plots symbols not defined in the character set.