Connecting to the Interface

This section explains how to identify the machine's interface and connect the machine according to the network environment.

A network interface cable with a ferrite core must be used for RF interference suppression.

connecting to the interfaces illustration (numbered callout illustration)

Gigabit Ethernet port (optional)
Port for using the 1000BASE-T, 100BASE-TX, or 10BASE-T cable
USB Host Interface
Port for connecting the USB interface cable
Use this interface to connect the machine to a card authentication device or memory card reader.
10BASE-T/100BASE-TX port
Port for connecting the 10BASE-T or 100BASE-TX cable
USB2.0 port
Port for connecting the USB2.0 interface cable.
Wireless LAN interface unit (optional)
This unit allows you to connect the machine to an IEEE 802.11 a or IEEE 802.11 b/g wireless LAN.

The Ethernet and Gigabit Ethernet port cannot be used simultaneously. If the optional Gigabit Ethernet board is installed, connect the Ethernet cable to the port on the Gigabit Ethernet board Communication with the machine will fail if cables are connected to both ports simultaneously.