



	Manuals Contents Previous Next

Top Page > About This Machine > Adding Toner > Adding Toner

Adding Toner

This section describes how to add and store toner.

Do not incinerate toner (new or used) or toner containers. Doing so risks burns. Toner will ignite on contact with naked flame.

Do not store toner (new or used) or toner containers anywhere near naked flames. Doing so risks fire and burns. Toner will ignite on contact with naked flame.

Do not incinerate spilled toner or used toner. Toner dust might ignite when exposed to an open flame.

Do not crush or squeeze toner containers. Doing so can cause toner spillage, possibly resulting in dirtying of skin, clothing, and floor, and accidental ingestion.

Keep toner (used or unused) and toner containers out of reach of children.

If toner or used toner is inhaled, gargle with plenty of water and move into a fresh air environment. Consult a doctor if necessary.

If toner or used toner gets into your eyes, flush immediately with large amounts of water. Consult a doctor if necessary.

If toner or used toner is swallowed, dilute by drinking a large amount of water. Consult a doctor if necessary.

When removing jammed paper or replacing toner, avoid getting toner (new or used) on your clothing. If toner comes into contact with your clothing, wash the stained area with cold water. Hot water will set the toner into the fabric and make removing the stain impossible.

When removing jammed paper or replacing toner, avoid getting toner (new or used) on your skin. If toner comes into contact with your skin, wash the affected area thoroughly with soap and water.

Fault may occur if you use toner other than the recommended type.
When adding toner, do not turn off the operation switch. If you do, settings will be lost.
Always add toner when the machine instructs you.
When a message "Add Toner" is shown on the display, replace the applicable toner.
Store toner containers in a cool, dry place free from direct sunlight.
Store toner on a flat surface.

You can check the name of the required toner and the replacement procedure using the "Add Toner" screen.
Press [System Status] to check contact number where you can order supplies. See “Checking Machine Status and Settings”, Troubleshooting.

Related topics

Replacing Toner
Sending Scanned Documents When Toner Has Run Out
Used Toner