Order of Option Installation

Attach the paper feed unit.

Attach the paper feed units to the bottom of the printer.

You can attach up to three paper feed units. Up to 2300 sheets of paper can be loaded in total.

If the paper feed unit is set on the floor, the tip-resistant caster table (option) is required for safe usage. The tip-resistant caster table can only be installed by a service representative. Contact your service representative for details.

If you are using Type 1 model, install the SDRAM module.

Install the expansion memory in the controller board slot.

There are two types of memory units, 256 MB and 512 MB.

If you are using Type 1 model, install the hard disk.

Install the optional interface board.

Install the optional Gigabit Ethernet board, Wireless LAN interface unit, or IEEE 1284 interface board in the slot.

Insert SD card options.

Install the Data overwrite security unit, NetWare card, camera direct print card, VM card, or HDD encryption unit.

Insert these units into the SD card slot on the controller board.

If you want to use two or more SD cards that can be inserted in the same slot, contact your sales and service representative.