Skip header
 

Top Page > Software Guide > Using a Printer Server > Using NetWare

Using NetWare

This section describes the setting procedure for network printers in the NetWare environment. In the NetWare environment, you can connect the printer as a "print server" or "remote printer".

Important

  • IPv6 cannot be used on this function.

Setting procedure

  • When using the printer as a print server

    1. Install the network interface board.

    2. Turn the printer off and then back on.

  • When using the printer as a remote printer

    1. Install the network interface board.

    2. Configure NetWare.

    3. Start the print server.

    Note

    • This procedure assumes an environment is already prepared for normal NetWare running the printing service setting.

    • The procedure is explained with the following example settings:

      • File server name ...CAREE

      • Print server name ...PSERV

      • Printer name ...R-PRN

      • Queue name ...R-QUEUE

Related topics

Setting Up as a Print Server (NetWare 3.x)
Setting Up as a Print Server (NetWare 4.x, 5 / 5.1, 6 / 6.5)
Using Pure IP in the NetWare 5 / 5.1 or 6 / 6.5 Environment
Setting Up as a Remote Printer (NetWare 3.x)
Setting Up as a Remote Printer (NetWare 4.x, 5 / 5.1, 6 / 6.5)