Adding Toner (Print Cartridge)

Do not incinerate toner (new or used) or toner containers. Doing so risks burns. Toner will ignite on contact with naked flame.

Do not store toner (new or used) or toner containers anywhere near naked flames. Doing so risks fire and burns. Toner will ignite on contact with naked flame.

Keep the polythene materials (bags, gloves, etc.) supplied with this machine away from babies and small children at all times. Suffocation can result if polythene materials are brought into contact with the mouth or nose.

Do not crush or squeeze toner containers. Doing so can cause toner spillage, possibly resulting in dirtying of skin, clothing, and floor, and accidental ingestion.

If toner or used toner is inhaled, gargle with plenty of water and move into a fresh air environment. Consult a doctor if necessary.

If toner or used toner gets into your eyes, flush immediately with large amounts of water. Consult a doctor if necessary.

If toner or used toner is swallowed, dilute by drinking a large amount of water. Consult a doctor if necessary.

When removing jammed paper or replacing toner, avoid getting toner (new or used) on your clothing. If toner comes into contact with your clothing, wash the stained area with cold water. Hot water will set the toner into the fabric and make removing the stain impossible.

When removing jammed paper or replacing toner, avoid getting toner (new or used) on your skin. If toner comes into contact with your skin, wash the affected area thoroughly with soap and water.

When removing toner, be careful not to drop it.
Do not forcefully push toner in.
When handling toner, never stand them up on either end or position them upside down.
Store toner in a cool dark place.

If toner are not changed when necessary, printing will become impossible. We recommend keeping a stock of containers.
Toner (consumables) are not covered by warranty. However, if there is problem, contact the store where they were purchased.

Replace the toner cartridge if the following message appears on the display:

"Add Toner: (color)"

Illustration of message

A combination of one to four colors, yellow, magenta, cyan, black, appears in "(color)".
If cyan, magenta, or yellow toner runs out, you can print in black and white using black toner. Change the color mode setting to Black and White using the printer driver.
If black toner runs out, you cannot print in black and white or color until the black toner cartridge is replaced.

When the following message appears on the display, the toner should be replaced soon. Prepare a new toner.

Illustration of message

Open the top cover by pulling the handles on the left side.
From the back, the toner bottle is installed in the order of yellow (Y), magenta (M), cyan (C), and black (K).
Remove the toner bottle you want to replace.
- Do not shake the removed toner bottle. Any remaining toner may leak.
- Pull the toner bottle out slowly and carefully to prevent leakage.
- Place the old toner bottle on paper or some other material to avoid dirtying your workspace.
Take the new toner bottle out of its box, and then shake the toner bottle up and down seven or eight times. When holding or shaking the toner bottle, take care to hold the actual bottle, not the bottle's cover.
Even distribution of toner within the bottle improves print quality.
Install the yellow toner bottle first. Holding the toner bottle horizontally with the label facing up, align the label with the position of the triangular mark.
Be sure to set the toner bottles so that they are straight and flat.
Carefully align the label on each toner bottle with the triangular mark on the receiving side.
Push in the toner bottle until you hear a clicking sound.
Do not repeatedly install and remove toner bottle. Doing so results in toner leak.
Close the top cover.
Wait while the toner loads.
To avoid malfunction, do not turn off the power while "Loading Toner" appears on the display.

Cooperate with the Toner Recycling Program, whereby are collected used toner. For details, consult with the dealer where you purchased the printer, or with a sales or service representative.